dotmod Switch Nano 25W Pod System Review
The dotmod Switch Nano 25W Pod System is a small, draw-activated pod system with a 1000mAh built-in battery, an aluminum body and adjustable airflow. It takes 3ml Switch refillable pods with mesh coils, and dotmod says Switch pre-filled pods fit it too. See more from dotmod or compare other pod systems.
Switch Nano Highlights
Up to 25W
dotmod rates the Switch Nano at up to 25W from its 1000mAh built-in battery.
Draw-Activated
It fires when you draw and turns on by itself when a pod is in. A light shows the battery level in green, blue or red.
Aluminum Body
dotmod builds it from aluminum, with adjustable airflow and a magnetic pod.
Vape While Charging
It charges over USB-C, and dotmod says it supports pass-through charging.
Switch Nano Specs
Device
- Battery: 1000mAh, built in
- Output: up to 25W
- Firing: draw-activated
- Airflow: adjustable
- Battery light: green, blue or red by charge level; solid green for 3 minutes when it’s full
- Charging: USB-C; you can vape while it charges
- Body: aluminum
- Size: 62.9 × 42.3 × 21.4mm
- Safety: 10-second cut-off; short-circuit, open-circuit, pod resistance, overheat and low-voltage protection
Switch Pods
- Pods: Switch refillable pods (0.6Ω, 0.8Ω, 1.0Ω) and Switch pre-filled pods
- Capacity: 3ml
- Fill: side fill under a silicone cap
- Coil: built-in mesh coil
- Fit: magnetic
Switch Nano Colors
- Options: Black, Purple, Red, Royal Blue, Silver, Tiffany Blue
Switch Nano Light Guide
dotmod’s manual gives these light signals:
| Light | Means |
|---|---|
| White, blinks 3 times | a pod is in and it’s on |
| White, flashes twice | short circuit in the pod |
| White, flashes 3 times | open circuit |
| Flashes 4 times | pod resistance out of range: replace the pod |
| Red, flashes 5 times | circuit board too hot |
| Red, blinks 8 times | battery low: recharge it |
| Blue, flashes 3 times | the 10-second cut-off |
How to Set Up the Switch Nano
- Take the pod out: pull it gently out of the device; magnets hold it in place.
- Fill the pod: open the silicone cap on the side, fill the pod and don’t overfill it.
- Fit the pod: close the cap and push the pod back in; the light blinks white 3 times as it turns on.
- Set the airflow: adjust it to the draw you like.
- Vape: draw on the mouthpiece; it fires when you draw.
- Charge it: use the USB-C port; a solid green light means it’s full. You can vape while it charges.
Who the Switch Nano Is For
The dotmod Switch Nano suits vapers who want a small, simple pod system that fires when you draw and takes refillable or pre-filled Switch pods. For a leather-finish box pod that sets its power from the pod, see the dotmod dotPod Nano.
Good to know: Switch pods have the coil built in, so you replace the whole pod. dotmod gives no wattage rating for the refillable pods; the Switch Nano tops out at 25W.
What’s in the Switch Nano Kit
- dotmod Switch Nano device
- 0.8Ω Switch replacement pod
- Lanyard
- User manual
dotmod’s box list doesn’t mention a charging cable.
































































Reviews
There are no reviews yet